Brand GTX Model number 4 Inch Type Dry Weight 1 pcs/0.100kg Place of origin Mide In China Material Tungsten steel carbon alloy Hole diameter 20mm Grit Type rock slabs,marble Thickness 1.3mm Product unit 1Pcs About this item When using a Dry Ultra-thin Rock Slab Ceramic Tile Glass Tile Saw Blade with an angle grinder, follow these steps and safety measures to ensure effective cutting and prolong the dry saw blade’s lifespan: Equipment Preparation Select the Right Angle Grinder: Ensure the angle grinder’s power and speed are suitable for the blade specifications. Inspect dry saw blade: Check the blade for any damage or deformation before installation. Do not use damaged blades. Install the Blade: Follow the angle grinder’s manual to properly install the blade, making sure it is securely fastened and aligned correctly. Operating Steps Prepare the Material: Secure the rock slab, ceramic tile, or glass tile firmly on a stable workbench to prevent movement. Mark the Cutting Line: Use a ruler and marker to draw the cutting line on the material for accurate cutting. Set Up the Angle Grinder: Ensure the angle grinder is off and plugged into a power source. Wear Protective Gear: Always wear safety goggles, gloves, and a dust mask for protection. Cutting Procedure Start the Angle Grinder: Hold the angle grinder firmly, switch it on, and allow the blade to reach full speed. Begin Cutting: – Gradually bring the blade into contact with the material, following the marked line slowly. – Maintain even pressure without forcing the blade to avoid damage to the blade or material. – Keep the angle grinder and material stable to minimize vibration. Cooling: Although it’s a dry-cut blade, proper cooling can extend its life and improve cutting efficiency. Use a small amount of water for lubrication and cooling if the grinder and blade specifications allow. Precautions Cutting Speed: Maintain a consistent cutting speed, avoiding sudden acceleration or deceleration. Cooling Breaks: Take occasional breaks during long cuts to let the blade cool down. Avoid Forcing the Cut: If you encounter resistance or the material is too hard, stop and inspect both the blade and material. Finishing the Cut: Once the cut is complete, turn off the angle grinder before removing the material to avoid injury from the spinning blade. Maintenance and Care Clean the Blade: After use, clean the blade to remove debris and dust. Storage: Store the blade in a dry place to prevent rust and corrosion. Regular Inspection: Regularly check the blade for wear and tear and replace it as needed to ensure optimal cutting performance. Safety Tips – Two-Hand Operation: Always use both hands to hold the angle grinder for better control. – Keep the Work Area Clean: Ensure the work area is clean and free of obstacles to prevent slips and falls. – Cutting Direction: Ensure the cutting direction matches the arrow on the blade to avoid kickback. By following these steps and precautions, you can safely and efficiently use a Dry Ultra-thin Rock Slab Ceramic Tile Glass Tile Saw Blade with an angle grinder for your cutting tasks. Product Details Show SKU: ceramic tile glass tile saw blad-1-2 Categories: Diamond Saw Blade, For Ceramic Tile Glass, For Granite Marble Stone, For Wood, Grinding Drum Wheel, Saw Blade Tag: Dry
